DATALOGIC QUICKSCAN QS2500 DRIVER

Comments to this Manuals Your Name. This function is used to show unknown bar code Code Name Transmission: After each successful bar code reading, the QS will Beep Control: If the append function is enabled and other symbols are read again with the appended code, then the codes are transmitted without the code ID, preamble, or prefix. Plug the USB cable into the terminal or computer. To program the QS, you must scan a series of programming bar codes in the correct order.

Uploader: Shakajora
Date Added: 1 November 2015
File Size: 20.83 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 61161
Price: Free* [*Free Regsitration Required]

When connecting to a Datalogic scanner aux.

Installation Installation Complete the following steps for the appropriate interface. Scanning Scanning Mode The trigger button must be pressed to activate scanning.

DATALOGIC QUICKSCAN QS PRODUCT REFERENCE MANUAL Pdf Download.

Connect the QS to the terminal or computer using the appro- priate interface cable. When this option is enabled, the QS will Checksum Transmission: This function is used to show unknown bar code Code Name Transmission: Double Confirm Double Confirm If this option is enabled, the QS will require a several successful decodings to confirm the bar code data. Code Length 2—64 02—64 even values only Use Global Min. Find the alphanumeric entry for the option setting you want, and scan the alphanumeric characters located in Appendix E.

  IOGEAR CAC CARD READER DRIVER DOWNLOAD

Wand Emulation Support for wand emulation is available only with the keyboard wedge interface. Disconnect the keyboard cable from the back of the qulckscan or computer. This function allows several symbols to be concatenated and be Append: Quickcan code name will be transmitted before the bar code data to identify the symbology.

Use the bar codes below to enable and config- ure wand emulation. The inside back cover of this manual contains a table of alphanumeric bar codes needed to program the various options. See page Datalkgic Id Setting: General purpose corded handheld linear imager bar datalofic reader 25 pages.

Barcodes,Inc.

Page 30 This function is used to show unknown bar code Code Name Transmission: Resetting The Qs Resetting the QS To return all Datalogc option settings to the factory defaults, scan the fol- lowing two bar codes, in the order shown: The inside back cover of this manual contains a table of alphanumeric bar codes needed to program the various options. The QS will beep instead of reading anything when the truncate value is more than the bar code data digits or the truncate leading value overlaps the truncate quivkscan value.

Page 40 This function data,ogic several symbols to be concatenated and be Append: Auto-detect – the scanner can automatically detect the interface hardware for all interfaces except Wand Emulation.

  DELL TRUEMOBILE 1100 WINDOWS XP DRIVER

QS will light up.

Programming the qs | Datalogic Scanning QUICKSCAN QS User Manual | Page 7 / 76

If the QS does not operate, turn off the terminal or ss2500 immediately and check all connections. The checksums are calculated as the sum mod 10 or 11 of the data digits. Find the alphanumeric entry for the option setting you want, and.

IBM interfaces – must be selected individually depending on the port used. Labels with length exceeding these limits will be rejected.

To program the QS, you must scan a series of programming bar codes in the correct order. Scan the Start Program bar code above the list of options see the table below.

Datalogic is a registered trademark of Datalogic S. Scan the Store Settings bar code in Appendix E. To program each option: To print the manual completely, please, download it.

Got it, continue to print.

Author: admin